D-64 Soldering Flux
A traditional high solids rosin flux for high temperature dip soldering of transformer pins and copper cables. Very good heat stabilisation when used with high temperature Sn/Pb/Ag, Sn/Ag and Sn/Cu alloys to allow quick soldering when using plastic body coils. High reliability J-STD 004 compliant flux type ROM1.
- Excellent solderability on copper, nickel, silver, gold, tin and soldered surfaces
- Clear amber residue leaves a solid protective layer over the solder joint
- Increased performance for high temperature soldering.
D-32 Soldering Flux
A lower solids version of D-64 (~20%), slightly lighter colour with a lower level of post soldering residue. Good heat stabilisation when used with high temperature Sn/Pb/Ag, Sn/Ag and Sn/Cu alloys to allow quick soldering when using plastic body coils. High reliability J-STD 004 compliant flux type ROM1.
- Excellent solderability on copper, nickel, silver, gold, tin and soldered surfaces
- Clear amber residue leaves a solid protective layer over the solder joint
- Increased performance for high temperature soldering.
KingsFlux No.30 Soldering Flux
A high solids (~30%), flux for high temperature soldering of transformer pins and copper cable tinning. Based on a clear resin, Leaves a clear transparent post soldering residue and is suitable for use with high temperature lead free and lead based alloys. Developed to contain no ionic halide (Cl- and Br-) and rated as flux type REL0 to J-STD 004B
- Excellent soldering for high transformer dipping applications
- Contains no Ionic Halide
- Clean post soldered residues
KingsFlux FT-08w Soldering Flux
A low solids (~4%), rosin / resin and VOC free flux for copper cable tinning when resin residues are not acceptable. The activator in FT-08w is neutralised with soldering temperature and leaves virtually zero non-corrosive residues after soldering.
- Water Based
- Powerful Wetting
- Reduced Heating Time
- Non Corrosive Residues
- Efficient on Plain Copper and Brass
- Very Clean Residues
KingsFlux FT-08s Soldering Flux
An alcohol based version of FT-08w allowing dipping of larger diameter copper cables where water may cause spatter in contact with molten solder in larger quantities. The activator in FT-08s is neutralised with soldering temperature and leaves virtually zero non-corrosive residues after soldering.
- Powerful Wetting
- Reduced Heating Time
- Non Corrosive Residues
- Efficient on Plain Copper and Brass
- Very Clean Residues
Want to know more about our range of fluxes, fill in the form below.